This will be an oval wall grill, about 3 feet wide by 4 feet tall, with the logos of the 7 chapters that make up the SBA. The SBA logo will be at the top of the frame. There will be 3 horizontal 1/4" x 1" bars, 2 logos will be riveted to the top and bottom bars and 3 will be on the middle bar.
Each chapter should bring a metal replica of their logo to the conference and give it to Glynn Holmes and Harry Brock who will rivet them to the frame. The finished grill will be auctioned to raise money for the SBA. Location of each logo on the frame will be determined by best fit of the logos to each other and the frame.
Size: The logo should fit within a 10" square space and should not be thicker than 3". The back should b flat so it can be riveted to the flat bar.
Material: any metals may be used.
Construction: any construction may be used but results of arc/MIG/TIG/torch welding or brazing should not be visible. Finish should be applied to your logo before bringing it to Madison.
Mounting: Leave or fabricate a flat space about 2" tall on the horizontal centerline on the backside of your piece. Drill 2 holes for 3/16" rivets on the centerline of your logo. Matching holes will be drilled in the 1/4" x 1" horizontal bars at Madison and the pieces riveted to the frame. If special rivets are desired for your logo they must be provided (with spares) along with any special setting tools.
AACB Logo -
